GCSE
BIOLOGY
8461/2H
Paper 2 Higher Tier
Mark scheme
June 2020
Version: 1.0 Final Mark Scheme
*jun208461/2H/MS*
MARK SCHEME – GCSE BIOLOGY – 8461/2H – JUNE 2020
2
Mark schemes are prepared by the Lead Assessment Writer and considered, together with the relevant
questions, by a panel of subject teachers. This mark scheme includes any amendments made at the
standardisation events which all associates participate in and is the scheme which was used by them in
this examination. The standardisation process ensures that the mark scheme covers the students’
responses to questions and that every associate understands and applies it in the same correct way.
As preparation for standardisation each associate analyses a number of students’ scripts. Alternative
answers not already covered by the mark scheme are discussed and legislated for. If, after the
standardisation process, associates encounter unusual answers which have not been raised they are
required to refer these to the Lead Examiner.
It must be stressed that a mark scheme is a working document, in many cases further developed and
expanded on the basis of students’ reactions to a particular paper. Assumptions about future mark
schemes on the basis of one year’s document should be avoided; whilst the guiding principles of
assessment remain constant, details will change, depending on the content of a particular examination
paper.
Further copies of this mark scheme are available from aqa.org.uk

Copyright information
AQA retains the copyright on all its publications. However, registered schools/colleges for AQA are permitted to copy material from this booklet for their own
internal use, with the following important exception: AQA cannot give permission to schools/colleges to photocopy any material that is acknowledged to a third
party even for internal use within the centre.
Copyright © 2020 AQA and its licensors. All rights reserved.
MARK SCHEME – GCSE BIOLOGY – 8461/2H – JUNE 2020
3
Level of response marking instructions
Level of response mark schemes are broken down into levels, each of which has a descriptor. The
descriptor for the level shows the average performance for the level. There are marks in each level.
Before you apply the mark scheme to a student’s answer read through the answer and annotate it (as
instructed) to show the qualities that are being looked for. You can then apply the mark scheme.
Step 1 Determine a level
Start at the lowest level of the mark scheme and use it as a ladder to see whether the answer meets the
descriptor for that level. The descriptor for the level indicates the different qualities that might be seen in
the student’s answer for that level. If it meets the lowest level then go to the next one and decide if it
meets this level, and so on, until you have a match between the level descriptor and the answer. With
practice and familiarity you will find that for better answers you will be able to quickly skip through the
lower levels of the mark scheme.
When assigning a level you should look at the overall quality of the answer and not look to pick holes in
small and specific parts of the answer where the student has not performed quite as well as the rest. If
the answer covers different aspects of different levels of the mark scheme you should use a best fit
approach for defining the level and then use the variability of the response to help decide the mark within
the level, ie if the response is predominantly level 3 with a small amount of level 4 material it would be
placed in level 3 but be awarded a mark near the top of the level because of the level 4 content.
Step 2 Determine a mark
Once you have assigned a level you need to decide on the mark. The descriptors on how to allocate
marks can help with this. The exemplar materials used during standardisation will help. There will be an
answer in the standardising materials which will correspond with each level of the mark scheme. This
answer will have been awarded a mark by the Lead Examiner. You can compare the student’s answer
with the example to determine if it is the same standard, better or worse than the example. You can then
use this to allocate a mark for the answer based on the Lead Examiner’s mark on the example.
You may well need to read back through the answer as you apply the mark scheme to clarify points and
assure yourself that the level and the mark are appropriate.
Indicative content in the mark scheme is provided as a guide for examiners. It is not intended to be
exhaustive and you must credit other valid points. Students do not have to cover all of the points
mentioned in the Indicative content to reach the highest level of the mark scheme.
An answer which contains nothing of relevance to the question must be awarded no marks.
MARK SCHEME – GCSE BIOLOGY – 8461/2H – JUNE 2020
4
Information to Examiners
1. General
The mark scheme for each question shows:
• the marks available for each part of the question
• the total marks available for the question
• the typical answer or answers which are expected
• extra information to help the Examiner make his or her judgement
• the Assessment Objectives, level of demand and specification content that each question is intended
to cover.
The extra information is aligned to the appropriate answer in the left-hand part of the mark scheme and
should only be applied to that item in the mark scheme.
At the beginning of a part of a question a reminder may be given, for example: where consequential
marking needs to be considered in a calculation; or the answer may be on the diagram or at a different
place on the script.
In general the right-hand side of the mark scheme is there to provide those extra details which confuse
the main part of the mark scheme yet may be helpful in ensuring that marking is straightforward and
consistent.
2. Emboldening and underlining
2.1 In a list of acceptable answers where more than one mark is available ‘any two from’ is used, with
the number of marks emboldened. Each of the following bullet points is a
potential mark.
2.2 A bold and is used to indicate that both parts of the answer are required to award the mark.
2.3 Alternative answers acceptable for a mark are indicated by the use of or. Different terms in the
mark scheme are shown by a / ; eg allow smooth / free movement.
2.4 Any wording that is underlined is essential for the marking point to be awarded.
MARK SCHEME – GCSE BIOLOGY – 8461/2H – JUNE 2020
5
3. Marking points
3.1 Marking of lists
This applies to questions requiring a set number of responses, but for which students have
provided extra responses. The general principle to be followed in such a situation is that ‘right +
wrong = wrong’.
Each error/contradiction negates each correct response. So, if the number of error/contradictions
equals or exceeds the number of marks available for the question, no marks can be awarded.
However, responses considered to be neutral (indicated as * in example 1) are not penalised.
Example 1: What is the pH of an acidic solution?
[1 mark]
Student  | Response  | Marks
awarded
1  | green, 5  | 0
2  | red*, 5  | 1
3  | red*, 8  | 0Example 2: Name two planets in the solar system.
[2 marks]
Student  | Response  | Marks awarded
1  | Neptune, Mars, Moon  | 1
2  | Neptune, Sun, Mars,
Moon | 03.2 Use of chemical symbols/formulae
If a student writes a chemical symbol/formula instead of a required chemical name, full credit can
be given if the symbol/formula is correct and if, in the context of the question, such action is
appropriate.
3.3 Marking procedure for calculations
Marks should be awarded for each stage of the calculation completed correctly, as students are
instructed to show their working. Full marks can, however, be given for a correct numerical
answer, without any working shown.
3.4 Interpretation of ‘it’
Answers using the word ‘it’ should be given credit only if it is clear that the ‘it’ refers to the correct
subject.
MARK SCHEME – GCSE BIOLOGY – 8461/2H – JUNE 2020
6
3.5 Errors carried forward
Any error in the answers to a structured question should be penalised once only.
Papers should be constructed in such a way that the number of times errors can be carried forward
is kept to a minimum. Allowances for errors carried forward are most likely to be restricted to
calculation questions and should be shown by the abbreviation ecf in the marking scheme.
3.6 Phonetic spelling
The phonetic spelling of correct scientific terminology should be credited unless there is a possible
confusion with another technical term.
3.7 Brackets
(…..) are used to indicate information which is not essential for the mark to be awarded but is
included to help the examiner identify the sense of the answer required.
3.8 Allow
In the mark scheme additional information, ‘allow’ is used to indicate creditworthy
alternative answers.
3.9 Ignore
Ignore is used when the information given is irrelevant to the question or not enough to gain the
marking point. Any further correct amplification could gain the marking point.
3.10 Do not accept
Do not accept means that this is a wrong answer which, even if the correct answer is given as
well, will still mean that the mark is not awarded.
4. Level of response marking instructions
Extended response questions are marked on level of response mark schemes.
• Level of response mark schemes are broken down into levels, each of which has a descriptor.
• The descriptor for the level shows the average performance for the level.
• There are two marks in each level.
Before you apply the mark scheme to a student’s answer, read through the answer and annotate it
(as instructed) to show the qualities that are being looked for. You can then apply the mark scheme.
Step 1: Determine a level
Start at the lowest level of the mark scheme and use it as a ladder to see whether the
answer meets the descriptor for that level. The descriptor for the level indicates the
different qualities that might be seen in the student’s answer for that level. If it meets the
lowest level then go to the next one and decide if it meets this level, and so on, until you have a
match between the level descriptor and the answer.
MARK SCHEME – GCSE BIOLOGY – 8461/2H – JUNE 2020
7
When assigning a level you should look at the overall quality of the answer. Do not look to penalise
small and specific parts of the answer where the student has not performed quite as well as the rest.
If the answer covers different aspects of different levels of the mark scheme you should use a best
fit approach for defining the level.
Use the variability of the response to help decide the mark within the level, ie if the response is
predominantly level 2 with a small amount of level 3 material it would be placed in level 2 but be
awarded a mark near the top of the level because of the level 3 content.
Step 2: Determine a mark
Once you have assigned a level you need to decide on the mark. The descriptors on how to
allocate marks can help with this.
The exemplar materials used during standardisation will help. There will be an answer in the
standardising materials which will correspond with each level of the mark scheme. This answer will
have been awarded a mark by the Lead Examiner. You can compare the student’s answer with the
example to determine if it is the same standard, better or worse than the example. You can then
use this to allocate a mark for the answer based on the Lead Examiner’s mark on the example.
You may well need to read back through the answer as you apply the mark scheme to clarify points
and assure yourself that the level and the mark are appropriate.
Indicative content in the mark scheme is provided as a guide for examiners. It is not intended to be
exhaustive and you must credit other valid points. Students do not have to cover all of the points
mentioned in the indicative content to reach the highest level of the mark scheme.
You should ignore any irrelevant points made. However, full marks can be awarded only if there are
no incorrect statements that contradict a correct response.
An answer which contains nothing of relevance to the question must be awarded no marks.
MARK SCHEME – GCSE BIOLOGY – 8461/2H – JUNE 2020
8
Question  | Answers  | Extra information  | Mark  | AO /
Spec. Ref.
01.1  | bacteria
fungi | allow singular
allow mould
ignore microbes / germs /
decomposers
do not accept viruses | 1 1 | AO1
4.7.2.2
4.7.2.3
01.2  | fatty acid(s)  | 1  | AO2
4.7.2.3
4.2.2.1
RPA10